PT100 Temperature Sensor

PT100 Temperature Sensor

PT100 sensors are used for high temperature with high accuracy 3D printing. You can use them on your E3D V6 HotEnd instead of thermistors or thermocouples. PT100's are able to measure temperatures up to 400°C, and are more accurate than most thermistors and thermocouples.

The PT100 sensors are easy to handle, being of a metal cartridge type construction. The PT100 sensor will fit in the standard E3D V6, Lite6, (new heater block), Chimera and Kraken.

IMPORTANT : PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.

The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.

A long cable (1m) is also provide for connection to the electronic board.

Photos non contractual.